2 Channel, common time base

Please be advised

The 715 family of Danfoss programmers have now been replaced by the Mk18 Range. Each product in this new range have the suffix of Si which denotes the programmer's ability to indicate when the boiler is in need of a service (Si = Service Interval). Programming information remains essentially the same. If you require a user guide to any of these models please follow the link below

Please click here for further details of the new range

The CP715 can be configured by the installer at time of installation to provide 7 day, 24 hour, or 5 day/2 day operation and either 2 ON/OFF's or 3 ON/OFF's per day, allowing the time control to be tailored to match the specific requirement of the consumer.

Additionally the programmer can be set for either 'pumped' or 'gravity' hot water.

The wallplates used follows the industry standard pattern, as used by many of the other time control manufacturers. This allows for direct replacement often without the need for re-wiring.

An additional range of accessories allow the CP715 to be used in other upgrade situations where the unit being replaced is larger than the new unit and a decoration scar would normally have been left.

Additional features such as convenient user overrides, built-in ready-to-use programmes, a day programme copy facility as well as a stylish, compact design and easy to read display make the CP715 the simple answer to all heating and hot water requirements.

See the new Danfoss CP715si programmer (with service interval)