7 Day, 24 Hour, 5 Day/2 Day single channel time switch

Please be advised

The 715 family of Danfoss programmers have now been replaced by the Mk18 Range. Each product in this new range have the suffix of Si which denotes the programmer's ability to indicate when the boiler is in need of a service (Si = Service Interval). Programming information remains essentially the same. If you require a user guide to any of these models please follow the link below

Please click here for further details of the new range

It is an ideal solution for combi-boilers, for systems having a common Heating and Hot Water zone, and for the control of additional heating zones.

The TS715 can be configured by the installer at time of installation to provide 7 day, 24 hour, or 5 day/2 day operation and either 2 ON/OFF's or 3 ON/OFF's per day, allowing the time switch to be tailored to match the specific requirement of the consumer.

The wallplate used follows the industry standard pattern, as used by many of the other time control manufacturers. This allows for direct replacement often without the need for re-wiring.

An additional range of accessories allow the TS715 to be used in other upgrade situations where the unit being replaced is larger than the new unit and a decoration scar would normally have been left.

Additional features such as convenient user overrides, built-in ready-to-use programmes, a day programme copy facility as well as a stylish, compact design and easy to read display make the TS715 the simple answer to all heating and hot water requirements.
 

See the new Danfoss TS715si programmer (with service interval)