|
Home
Up
Gledhill Stainless Lite
Gledhill Torrent Solar
GulfStream A-Class Boiler Thermal Store
BoilerMate A Class
Gledhill BoilerMate SP
BoilerMate
Thermal Store
Gledhill Accolade A Class
Gledhill Electramate
Gledhill Boilers
Gledhill SystemMate
Xstreme unvented hot water
Gledhill PulsaCoil
| |
|
BoilerMate
A-Class SP |
Heating and Mains
Pressure Hot Water System
for Sealed Primary Systems |
|
|
We are
UK's Number One Supplier of Gledhill Products |
 |
Now smaller and lighter with an even
bigger output
So you can specify a
smaller unit to achieve the same high performance.
Unlike unvented cylinders BoilerMate A-Class
does not require an annual service
The appliance's advanced
construction ensures a long life and the primary store design removes the
need for annual checks on sacrificial anodes, found on many unvented units.
Will produce more than
twice the hot water
per hour of most stainless unvented cylinders
Sufficient to fill a
bath in under 4 minutes, BoilerMate A-Class SP is eminently suitable for
multi-bathroom properties. A powerful shower can also be used without the
need for expensive pumps.
SWITCH 'peace of mind'
for the installer, developer and homeowner in the event of a boiler failure
comes as standard
It’s like having a
service engineer with each unit - instant response to boiler failure
restores heating and hot water at the press of a button.
All the necessary components for the system are
plumbed and wired
internally
BoilerMate A-Class SP is
a true appliance. With all its system components concealed behind a
beautifully engineered outer case, it consigns cupboard pipework to the
history books and turns installation time into minutes.
On board diagnostics that can be interrogated
remotely and fault tolerant electronics
give robust performance
Manual fill – no overflow or
run-off pipe needed |
 |
Easy to
transport, handle & install
All models are supplied
shrink wrapped with built in
moulded lifting handles. All controls and pipe-work are
mounted on the front face of the unit for ease of
installation and maintenance. Gledhill’s revolutionary design enables rapid
second fixing using copper or approved plastic piping.
Storage
Vessel
Plumbed and wired with:
- SWITCH
emergency heating and hot water back up
- Grundfos UPS pump - Boiler circuit
- Grundfos UPR pump - Hot water
- F&E Tank complete with fittings
- Full control and diagnostic system
- Clock- electro-mechanical or digital
- Fixing pallet
- Plate heat exchanger
There is no requirement for:
- Motorised valves and boiler bypass
- Pressure or temperature relief valves
For OPEN
VENTED systems -
BoilerMate A-Class OV
For SEALED HEATING SYSTEMS -
BoilerMate A-Class SP*
(*previously
known as the Systemate)
Resistance to scale
- The immersion heater
and primary coil can never scale
because they are in primary water
- BoilerMate A-Class is designed to cope on the
secondary side with most hard water situations
(<280ppm). For extreme situations (>280ppm)
we
can supply a Gledhill in-line scale inhibitor fitted for
very little extra
Approvals
BoilerMate has been
tested by WRAS, a member of the European Organisation for Technical
approvals (EOTA) and found to comply with Water Regulations. In performance,
it complies with the requirements of BS6700 and meets the NHBC criteria for
domestic properties. Gledhill Water Storage Ltd also operates a quality
management system audited and accepted by the BSI in accordance with BS EN
ISO 9001:2000. |
 |
|
|
|
Gledhill
products are available on short lead times - straight to your door!
Ring to enquire |
|
The
BoilerMate A-Class comes complete with the PLUS Emergency Heating and Hot
Water Back Up - CLICK
HERE to learn more |
|
|
| * The BMA 225 appliance
is suitable for use in larger properties because it produces the same
'peak hour output' as a typical 350-400 litre unvented cylinder |
For complimentary
boilers see -
Gledhill HE |
|